Location: USA, ROCKVILLE CENTRE NEW YORK

4.5" Cincinnati Pelletizing Line.
4.5" Cincinnati Pelletizing Line · 4 1/2 " Cincinnati Milacron Apex Series extruder and spare screw · 30:1 L/D · Water cooled barrel-6 zones · Vent barrel – with vacuum pump assembly · 42” centerline with 10” base riser · 10 die zones 230/3/60 · Operators panel · 250 HP Saftronics drive (dcM series) with electrical panel, primary power 460/3/60 · Service rating 250 HP/ 450 HP catalog rating, 1750 RPM input/ 152 RPM output · Equipped with a Flender Gearbox SDN320 · Total FLA 535 · Spare two stage extrusion screw with a Maddox tip · Extruder was running prior to shut down. There is a dent in the shroud that can be repaired · Previous service polypropylene: 900-1000 LBS. HR · Attached are original electrical prints · Gneuss Model SF 150 Continuous Screen Changer · Removable Pod inserts · Mode of operation: When a pressure increase upstream of the filter due to contamination is registered, the filter disk is indexed by means of a hydraulic drive. This guarantees that the free screen area is always kept constant and that the pressure variation in front of the filter is < 1.5 bar · Vertical Strand Transition/Die · Vertical 90 degree transition · Three (3) 80 hole die plates · Strand water bath with support legs · (2) IMCS day bin hoppers · Seller would consider splitting off the extruder from the screen changer-please inquire · Equipment was running and barrel purged clean by a global manufacture prior to shut down and is presently stored in a warehouse, so equipment doesn't show well in the pictures - can break out and sell Gneuss SF 150 screen changer